Creating a set using the same programatic interface as creating calculated metrics

2 Comments

  • Elaine
    Zendesk Customer Care

    Hi Travis,

    It is normal behavior in Explore to only show the first 100 values in any attribute's list of values if it has more than 100 values. In order for you to see the other values, you will need to click on the arrow on the right side next to the Apply button from the screenshot you provided above.

    Once you're on the second page or a higher page number of the attribute's list of values, you should be able to see an arrow on the left side next to the Apply button so you can go back to a lower page number and review the previously selected values.

    This goes the same with creating a Set in a report, but the arrows to the next and previous pages are found beside the Search bar as seen in the screenshot below:

    I hope this helps! Stay safe! (:

    0
  • Travis Marsh

    This is exactly what I needed. Thank you!

    0

Please sign in to leave a comment.

Powered by Zendesk