Creating a set using the same programatic interface as creating calculated metrics
RespondidaI'm using Zendesk Explore, and I need to create a set of ~200 items. Specifically, I need to create a list of 200 tags that will regularly be shown on reports and hide ~200 more that should not be shown.
The challenge is that the set stops showing entries after 100 entries. Note the alphabetic list below stops at 100 at the letter 'E' (about 25% through the list).
I can create a standard Calculated field with a simple 'If/Then' statement like this one
Is there any way to do something similar for creating a set? If so, I believe I know how to add all ~200 items I need into that single formula line and I would be all...set. Sorry, I couldn't help myself with the pun.
Any other ideas also welcome.
-
Hi Travis,
It is normal behavior in Explore to only show the first 100 values in any attribute's list of values if it has more than 100 values. In order for you to see the other values, you will need to click on the arrow on the right side next to the Apply button from the screenshot you provided above.
Once you're on the second page or a higher page number of the attribute's list of values, you should be able to see an arrow on the left side next to the Apply button so you can go back to a lower page number and review the previously selected values.
This goes the same with creating a Set in a report, but the arrows to the next and previous pages are found beside the Search bar as seen in the screenshot below:
I hope this helps! Stay safe! (:
-
This is exactly what I needed. Thank you!
Por favor, entrar para comentar.
2 Comentários